Enrollment Url (Ca Profile Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
enrollment url <url>
Use the enrollment url command to specify the URL of the CA to which the AOS should send certificate
requests.
Syntax Description
<url>
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Functional Notes
When entering the URL http:// is required, followed by the IP address or DNS name of the CA. If the port
number is something other than 80, include it after the IP address or DNS name separated with a colon (:).
The CA may have other necessary information to include in the CGI path before ending with the actual CGI
program. An example template to follow is http://hostname:port/path/to/program.exe.
Use the default program pkiclient.exe without specifying it, end the URL with a slash (/). Otherwise, you
must enter the program name to use. For example, http://10.10.10.1:400/abcdefg/ will assume
pkiclient.exe as the program (but not including the terminating slash is a configuration error).
Specifying this command will override the enrollment terminal setting as described previously (refer to
enrollment terminal on page 1032
Usage Examples
The following example specifies http://CAserver/certsrv/mscep/mscep.dll as the URL to which the AOS
will send certificate requests:
(ca-profile)#enrollment url http://CAserver/certsrv/mscep/mscep.dll
61200990L1-35E
Specifies the certificate authority's URL (e.g.,
http://10.10.10.1:400/abcdefg/pkiclient.exe).
Command was introduced.
).
Copyright © 2005 ADTRAN
CA Profile Configuration Command Set
1033