Bridge-Group Bpduguard Command (Ppp Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
bridge-group <group#> bpduguard [enable | disable]
Use the bridge-group bpduguard command to block BPDUs from being received on this interface. To
return to the default value, use the no form of this command.
Syntax Description
<group#>
enable
disable
Default Values
By default, this command is set to disable.
Applicable Platforms
This command applies to the NetVanta 5000 Series units.
Command History
Release 5.1
Usage Examples
The following example enables the BPDU guard on the interface:
(config)#interface ppp 1
(config-ppp 1)#bridge-group 1 bpduguard enable
61200990L1-35E
Assigns a bridge group number (range: 1 to 255).
Enables the BPDU block.
Disables the BPDU block.
Command was introduced.
Copyright © 2005 ADTRAN
PPP Interface Configuration Command Set
892