Frame Relay Sub-Interface Config Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
F R
RAME ELAY
To activate the Frame Relay Sub-Interface Configuration mode, enter the interface frame-relay command
(and specify a sub-interface) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface frame-relay 1.16
(config-fr 1.16)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
description <text>
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dial-backup commands
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password>
page 738
frame-relay commands
ip commands begin on page 744
lldp receive on page 772
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
mtu <size> on page 775
spanning-tree commands
61200990L1-35E
S -I
UB NTERFACE
on page 31
on page 715
on page 718
on page 719
on page 720
begin on page 722
begin on page 740
on page 773
begin on page 776
Copyright © 2005 ADTRAN

Frame Relay Sub-Interface Config Command Set

C C
ONFIG OMMAND
S
ET
on
714