Default-Metric (Router (Rip) Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
default-metric <value>
Use the default-metric command to set the default metric value for the RIP routing protocol. Use the no
form of this command to return to the default settings.
Syntax Description
<value>
Default Values
By default, this value is set at 0.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, 5000 and Total Access 900 Series
units.
Command History
Release 3.1
Functional Notes
The metric value defined using the redistribute command overrides the default-metric command's metric
redistribute ospf [metric <value>]
setting. Refer to
Usage Examples
The following example shows a router using both RIP and OSPF routing protocols. The example
advertises OSPF-derived routes using the RIP protocol and assigns the OSPF-derived routes a RIP metric
of 10.
(config)#router rip
(config-rip)#default-metric 10
(config-rip)#redistribute ospf
61200990L1-35E
Sets the default metric value (range: 1 to 4,294,967,295 Mbps).
Command was introduced.
Copyright © 2005 ADTRAN
Router (RIP) Configuration Command Set
on page 1140
for related information.
1136