Router (Pim Sparse) Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
R (PIM S
OUTER
To activate the Router (PIM Sparse) Configuration mode, enter the router pim-sparse command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router pim-sparse
(config-pim-sparse)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
join-prune-msg-interval <seconds>
rp-address <ip address> access-group <access-list-name>
spt-threshold <packets> infinity
61200990L1-35E
) C
PARSE ONFIGURATION
on page 1130
on page 1133
Copyright © 2005 ADTRAN

Router (PIM Sparse) Configuration Command Set

C
OMMAND
on page 1131
S
ET
1129