Match Address Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
match address <listname>
Use the match address command to assign an IP access list to a crypto map definition. The access list
designates the IP packets to be encrypted by this crypto map. Refer to ip access-list extended <listname>
on page 344 for more information on creating access lists.
Syntax Description
<listname>
Default Values
By default, no IP access lists are defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Functional Notes
Crypto map entries do not directly contain the selectors used to determine which data to secure. Instead,
the crypto map entry refers to an access control list. An access control list (ACL) is assigned to the crypto
map using the match address command. If no ACL is configured for a crypto map, then the entry is
incomplete and will have no effect on the system.
The entries of the ACL used in a crypto map should be created with respect to traffic sent by the ADTRAN
product. The source information must be the local ADTRAN product and the destination must be the peer.
Only extended access lists can be used in crypto maps.
61200990L1-35E
Specifies the name of the access list you wish to assign to this crypto map.
Command was introduced.
Copyright © 2005 ADTRAN
Crypto Map IKE Command Set
1046