Snmp Trap Threshold-Reached (T1 Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide T1 Interface Configuration Command Set
snmp trap threshold-reached
Use the snmp trap threshold-reached command to control the Simple Network Management Protocol
(SNMP) variable adGenAOSDs1ThresholdReached (adGenAOSDs1-Ext MIB) to enable the interface to
send SNMP traps when a DS1 performance counter threshold is reached. Use the no form of this command
to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the adGenAOSDs1ThresholdReached OID is enabled for all interfaces.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example disables SNMP threshold reached trap on the T1 interface:
(config)#interface t1 1/1
(config-t1 1/1)#no snmp trap threshold-reached
61200990L1-35E Copyright © 2005 ADTRAN 617