Databits Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
databits [7 | 8]
Use the databits command to set the number of databits per character for a terminal session. This value
must match the configuration of your VT100 terminal or terminal emulator software. The default is 8
databits per character. Use the no form of this command to return to the default value.
Syntax Description
7
8
Default Values
By default, the databits are set to 8.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example configures 7 databits per character for the console terminal session:
(config)#line console 0
(config-con 0)#databits 7
61200990L1-35E
Specifies 7 data bits per character.
Specifies 8 data bits per character.
Command was introduced.
Copyright © 2005 ADTRAN
Line (Console) Interface Config Command Set
473