Client Authentication Server List Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
client authentication server list <listname>
Use the client authentication server list command to enable the unit to act as an Xauth server (edge
device).
Syntax Description
<listname>
Default Values
By default, the router does not act as an Xauth server and extended authentication is not performed.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Functional Notes
When this IKE policy is negotiated and the peer has indicated Xauth via the IKE authentication method
and/or the Xauth vendor ID, this command allows the unit to perform as an Xauth server (edge device).
The specified AAA login method is used to identify the location of the user authentication database. The
client authentication host and the client authentication server commands are mutually exclusive.
Refer to client configuration pool <poolname>
Usage Examples
The following example enables Xauth as an Xauth server and specifies which AAA method list to use in
locating the user database:
(config-ike)#client authentication server list clientusers
61200990L1-35E
Specifies the named list created with the aaa authentication login command.
Command was introduced.
Copyright © 2005 ADTRAN
on page 1078 for more information.
IKE Policy Command Set
1077