Access-List Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
access-list <listname> [in | out]
Use the access-list command to assign a predefined access list to a BGP neighbor. This list is then used to
filter inbound and/or outbound BGP route updates. Use the no form of this command to return to default
settings.
Syntax Description
<listname>
in
out
Default Values
By default, no access lists are specified for filtering.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 9.3
Functional Notes
Before they can be assigned to a neighbor, access lists must first be defined using the ip access-list
ip access-list extended <listname>
commands. See
[permit | deny] <ip address>
Usage Examples
The following example uses the InWeb access list to filter all inbound BGP route updates:
(config)#router bgp-neighbor 192.22.73.101
(config-bgp-neighbor)#access-list InWeb in
61200990L1-35E
Assigns an access list to this BGP neighbor.
Specifies the filtering of all inbound BGP route updates.
Specifies the filtering of all outbound BGP route updates.
Command was introduced.
on page 350
for more information.
Copyright © 2005 ADTRAN
BGP Neighbor Configuration Command Set
on page 344 ip access-list standard <listname>
and
1096