Crypto Map Ike Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
C M IKE C
RYPTO AP
To activate the Crypto Map IKE mode, enter a valid version of the crypto map ipsec-ike command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto map Map-Name 10 ipsec-ike
(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
antireplay on page 1044
ike-policy <policy number>
match address <listname>
set peer <address>
set pfs [group1 | group2]
set security-association lifetime [kilobytes | seconds] <value>
set transform-set <setname1 - setname6>
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.
61200990L1-35E
OMMAND
on page 31
on page 1045
on page 1046
on page 1048
on page 1049
on page 1051
Copyright © 2005 ADTRAN
S
ET
on page 1050

Crypto Map IKE Command Set

1043