Set Metric Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Route Map Command Set
set metric <value>
Use the set metric command to specify a metric value for the route map. Use the no form of this command
to cancel the metric value.
Syntax Description
<value> Sets the metric value. (Valid range: 0 to 4,294,967,295.)
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series and
Total Access 900 Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
The following example sets the metric value for MyMap to 100:
(config)#route-map MyMap permit 100
(config-route-map)#set metric 100
61200990L1-35E Copyright © 2005 ADTRAN 1183