Framing (T3 Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
framing [m13 | cbit]
Use the framing command to configure the network framing format for a T3 physical interface.
Syntax Description
m13
cbit
Default Value
By default, all T3 interfaces are configured for C-bit parity framing.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1
Functional Notes
M13 is an asynchronous framing format that uses all 21 DS3 M-Frame C-bits for bit stuffing indicators.
End-to-end path parity and datalink capabilities are not provided by the standard M13 format. C-bit parity
framing differs from M13 by allowing monitoring of the data path (end-to-end) and supporting out-of-band
data links.
Usage Example
The following example configures the T3 interface for M13 framing:
(config)#interface t3 1/1
(config-t3 1/1)#framing m13
61200990L1-35E
Configures the interface for M13 framing.
Configures the interface for C-bit parity framing.
Command was introduced.
Copyright © 2005 ADTRAN
T3 Interface Configuration Command Set
623