Ip Proxy-Arp (Tunnel Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip proxy-arp <ip address> <subnet mask>
Use the ip proxy-arp command to enable proxy Address Resolution Protocol (ARP) on the interface. Use
the no form of this command to disable this feature.
Syntax Description
<ip address>
<subnet mask>
Default Values
By default, proxy-arp is enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 9.1
Functional Notes
In general, the principle of proxy ARP allows a router to insert its IP address in the source IP address field
of a packet (if the packet is from a host on one of its subnetworks). This allows hosts to reach devices on
other subnetworks without implementing routing or specifying a default gateway.
If proxy ARP is enabled, the AOS will respond to all proxy ARP requests with its specified MAC address
and forward packets accordingly.
Enabling proxy ARP on an interface may introduce unnecessary ARP traffic on the network.
Usage Examples
The following enables proxy ARP on the tunnel interface:
(config)#interface tunnel 1
(config-tunnel 1)#ip proxy-arp
61200990L1-35E
Defines the proxy ARP IP address in dotted decimal notation (for example:
192.22.73.101).
Specifies the subnet mask that corresponds to the listed IP address.
Command was introduced.
Copyright © 2005 ADTRAN
Tunnel Configuration Command Set
1012