Bridge-Group Edgeport Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
bridge-group <group#> edgeport [disable]
Use the bridge-group edgeport command to set this interface to be an edgeport. This configures the
interface to go to a forwarding state when the link goes up. To return to the default value, use the no form
of this command.
Syntax Description
<group#>
disable
Default Values
By default, this command is set to disable.
Applicable Platforms
This command applies to the NetVanta 5000 Series units.
Command History
Release 5.1
Usage Examples
The following example configures the interface to be an edgeport:
(config)#interface ppp 1
(config-ppp 1)#bridge-group 1 edgeport
An individual interface can be configured to not be considered an edgeport. For example:
(config)#interface ppp 1
(config-ppp 1)#bridge-group 1 edgeport disable
or
(config)#interface ppp 1
(config-ppp 1)#no bridge-group 1 edgeport
61200990L1-35E
Assigns a bridge group number (range: 1 to 255).
Optional. Configures the interface to not be the edgeport by default. This command is
designed to override the global setting of the
page 304 .
Command was introduced.
Copyright © 2005 ADTRAN
PPP Interface Configuration Command Set
bridge <group#> protocol ieee on
893