Show Ip Ospf Database Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show ip ospf database
Use the show ip ospf database command to display information from the open shortest path first (OSPF)
database regarding a specific router. There are several variations of this command which you can use to
obtain information about different OSPF link state advertisements. The variations are shown below:
show ip ospf <area-id> database
show ip ospf <area-id> database adv-router <ip address>
show ip ospf <area-id> database database-summary
show ip ospf <area-id> database external <link-state-id>
show ip ospf <area-id> database external <link-state-id> adv-router <ip address>
show ip ospf <area-id> database network <link-state-id>
show ip ospf <area-id> database network <link-state-id> adv-router <ip address>
show ip ospf <area-id> database router <link-state-id>
show ip ospf <area-id> database router <link-state-id> adv-router <ip address>
show ip ospf <area-id> database summary <link-state-id>
show ip ospf <area-id> database summary <link-state-id> adv-router <ip address>
Syntax Description
<area id>
<link-state-id>
<ip address>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1
61200990L1-35E
Optional. Displays area ID number associated with the OSPF address range. This
range is defined in the network router configuration command used to define the
particular area. Refer to
page 1122 for more information.
Optional. Identifies the portion of the Internet environment that is being described by
the advertisement. The value needed in this field is tied to the advertisement's LS
type.
Specifies the IP address in the form <A.B.C.D>.
Command was introduced.
Copyright © 2005 ADTRAN
network <ip address> <wildcard> area <area id>
Enable Mode Command Set
on
212