Show Ip Interfaces Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show ip interfaces [<interface> | brief]
Use the show ip interfaces command to display the status information for all IP interfaces (or a specific
interface).
Syntax Description
<interface>
brief
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Release 9.1
Release 11.1
Usage Examples
The following is a sample output of the show ip interfaces command:
>enable
#show ip interfaces
eth 0/1 is UP, line protocol is UP
Ip address is 10.10.10.1
Netmask is 255.255.255.0
MTU is 1500
Fastcaching is Enabled
RIP Authentication is Disabled
RIP Tx uses global version value
RIP Rx uses global version value
61200990L1-35E
Optional. Displays status information for a specific interface. If no interface is entered,
status information for all interfaces is displayed. Type show ip interfaces ? for a
complete list of applicable interfaces.
Displays an abbreviated version of interface statistics for all IP interfaces.
Command was introduced.
Command was expanded to include HDLC and tunnel interfaces.
Demand interface was added.
Copyright © 2005 ADTRAN
Enable Mode Command Set
207