Global Configuration Mode Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
G C
LOBAL ONFIGURATION
To activate the Global Configuration mode, enter the configuration command at the Enable Security
mode prompt. For example:
>enable
#configure terminal
(config)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
aaa accounting commands
aaa authentication commands
aaa authorization commands
aaa group server [radius | tacacs+] <listname>
aaa on on page 296
aaa processes <threads>
arp <ip address> <mac address> arpa
auto-config [filename <name> | restart | retry-count <number>| server <name or address>]
page 300
banner [exec | login | motd] <character> <message> <character>
boot system flash <filename> [no-backup | <backup filename>]
bridge <group#> protocol ieee
clock [auto-correct-dst | no-auto-correct-dst]
clock set <time> <day> <month> <year>
clock timezone <text>
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
page 310
crypto commands begin on page 313
61200990L1-35E
M
ODE
on page 31
begin on page 284
begin on page 287
begin on page 292
on page 298
on page 299
on page 304
on page 307
Copyright © 2005 ADTRAN

Global Configuration Mode Command Set

C
OMMAND
on page 294
on page 303
on page 305
on page 306
S
ET
on page 302
on
on
281