External-Loopback-Request Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide HSSI Interface Configuration Command Set
external-loopback-request
Use the external-loopback-request command to enable LC (loopback circuit C) input to control
loopbacks toward the network. Use the no form of this command to disable.
Syntax Description
No subcommands.
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 5000 Series units.
Command History
Release 7.1 Command was introduced.
Usage Examples
The following example enables the unit to accept external loopback requests:
(config)#interface hssi 1/1
(config-hssi 1/1)#external-loopback-request
61200990L1-35E Copyright © 2005 ADTRAN 600