Test-Pattern Command (T3 Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
test-pattern [clear | insert | ones | p215 | p223 | zeros]
Use the test-pattern command to activate the built-in pattern generator and begin sending the selected test
pattern toward the network. This pattern generation can verify a data path when used in conjunction with
an active loopback. Use the no form of this command to cease pattern generation.
Syntax Description
clear
insert
ones
p215
p223
zeros
Default Value
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1
Usage Example
The following example inserts a p215 test pattern:
(config)#interface t3 1/1
(config-t3 1/1)#test-pattern 2^15 insert
61200990L1-35E
Clears the test pattern error count.
Inserts an error into the currently active test pattern. Display the injected error
result using the show test pattern command.
Generates a test pattern of continous ones.
Generates a pseudorandom test pattern sequence based on a 15-bit shift register.
Generates a pseudorandom test pattern sequence based on a 23-bit shift register.
Generates a test pattern of continous zeros.
Command was introduced.
Copyright © 2005 ADTRAN
T3 Interface Configuration Command Set
630