Area Stub Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
area <area id> stub [no-summary]
Use the area stub command to configure an area as a stub area. Use the no form of this command to
disable stub-designation for areas defined as stubs using this command.
Syntax Description
<area id>
no-summary
Default Values
By default, OSPF is not enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Technology Review
It is important to coordinate configuration of all routers and access servers in the stub area. The area stub
command must be configured for each of those pieces of equipment. Use the area router configuration
command with the area default-cost command to specify the cost of a default internal router sent into a
stub area by an ABR. Refer to
Usage Examples
The following example configures area 2 as a stub area:
(config)#router ospf
(config-ospf)#area 2 stub
61200990L1-35E
Specifies an identifier for this stub area. Specifies as an integer (range: 0 to
4,294,967,295) or an IP address <A.B.C.D>.
Optional. Designates the area as a total stub area. No summary link advertisements
will be sent by the ABR into the stub area.
Command was introduced.
area <area id> default-cost <value>
Copyright © 2005 ADTRAN
Router (OSPF) Configuration Command Set
on page 1115
for related information.
1117