Ip Policy Route-Map - To Use The Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip policy route-map <policy name>
Use the ip policy route-map command to assign a policy route-map to this interface. Use the no form of
this command to remove the route-map policy.
Syntax Description
<policy name>
Default Values
By default, no policy route map is assigned to this interface.
Applicable Platforms
This command applies to the NetVanta 5000 and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example assigns the policy route map policy1 to the HDLC 1 interface:
(config)#interface hdlc 1
(config-hdlc 1)#ip policy route-map policy1
61200990L1-35E
Specifies the name of the policy route map to assign to this interface.
Command was introduced.
Copyright © 2005 ADTRAN
HDLC Command Set
831