Aaa Accounting Commands - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
aaa accounting commands <level> [<listname> | default] [none |
stop-only] [group <groupname> | group tacacs+]
Use aaa accounting commands to set parameters for AAA accounting. For more detailed information on
AAA functionality, refer to the Technology Review section of the command aaa on
Syntax Description
<level>
<listname>
default
none
stop-only
group <groupname>
group tacacs+
Default Values
By default, accounting is not enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example creates a list called myList and sets accounting for Level 1 commands at stop-only
activities:
(config)#aaa accounting commands 1 myList stop-only group tacacs+
To complete this command, Telnet must be applied to the lines. See Line (Telnet) Interface
Config Command Set
61200990L1-35E
Specifies the commands enable level. (1=unprivileged, 15 = privileged).
Specifies the name of the list.
Uses the default accounting list.
Disables accounting.
Records stop-only when service terminates.
Uses the specified group of remote servers for accounting.
Uses the TACACS+ server for accounting.
Command was introduced.
on page 491
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
for more detailed instructions.
on page 296.
284