Nat-Traversal Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
nat-traversal <version> [allow | disable | force]
Use the nat-traversal command to allow, force, or disable NAT traversal version 1 and 2 on a specific Ike
policy.
Syntax Description
<version>
allow
disable
force
Default Values
The defaults for this command are nat-traversal v1 allow and nat-traversal v2 allow.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 7.1
Usage Examples
The following example disables version 2 on Ike policy 1:
(config)#crypto ike policy 1
(config-ike)#nat-traversal v2 disable
61200990L1-35E
Specifies v1 or v2 to select the NAT traversal version.
Sets the IKE policy to allow the specified NAT traversal version.
Sets the IKE policy to disable the specified NAT traversal version.
Sets the IKE policy to force the specified NAT traversal version.
Command was introduced.
Copyright © 2005 ADTRAN
IKE Policy Command Set
1082