Respond Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
respond [main | aggressive | anymode]
Use the respond command to allow the IKE policy to respond to negotiations by a peer. Use the no form
of this command to allow the policy to only initiate negotiations.
Syntax Description
main
aggressive
anymode
Default Values
By default, respond to any mode is enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Functional Notes
By using the initiate and respond commands, you can configure the IKE policy to initiate and respond,
initiate only, or respond only. It is an error if you have both initiate and respond disabled.
Usage Examples
The following example configures the router to initiate and respond to IKE negotiations:
(config-ike)#respond anymode
(config-ike)#initiate main
61200990L1-35E
Specifies to respond only to main mode.
Specifies to respond only to aggressive mode.
Specifies to respond to any mode.
Command was introduced.
Copyright © 2005 ADTRAN
IKE Policy Command Set
1085