Show Bert Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide T3 Interface Configuration Command Set
show [bert]
The show bert command displays the results for the bit error rate test (BERT) conducted on the T3
interface.
Syntax Description
No subcommands.
Default Value
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1 Command was introduced.
Usage Examples
The following example instructs the unit to display the BERT results:
(config)#interface t3 1/1
(config-t3 1/1)#show bert
61200990L1-35E Copyright © 2005 ADTRAN 628