Community List Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
C L
OMMUNITY IST
To activate the Community List Configuration mode, enter the ip community-list command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#ip community-list listname
(config-comm-list)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
All other commands for this command set are described in this section in alphabetical order.
deny on page 1112
permit on page 1113
61200990L1-35E
C S
OMMAND ET
Copyright © 2005 ADTRAN

Community List Command Set

1111