Spanning-Tree Priority - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
spanning-tree priority <value>
Use the spanning-tree priority command to select the priority level of a port associated with a bridge. To
return to the default bridge-group priority value, use the no version of this command.
Syntax Description
<value>
Default Values
Be default, the bridge-group priority value is set at 28.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1
Functional Notes
The only time that this priority level is used is when two interfaces with a path to the root have equal cost.
At that point, the level set in this command will determine which port the bridge will use. Set the priority
value lower to increase the chance the interface will be used.
Usage Examples
The following example sets the maximum priority on the Frame Relay sub-interface labeled 1.16 in bridge
group 17:
(config)#interface frame-relay 1.16
(config-fr 1.16)#spanning-tree priority 0
61200990L1-35E
Priority value for the bridge group; the lower the value, the higher the priority (valid
range: 0 to 255).
Command was introduced.
Copyright © 2005 ADTRAN
Frame Relay Sub-Interface Config Command Set
781