Table of Contents
Advertisement
Command Reference Guide
T
C
UNNEL
ONFIGURATION
To activate the Tunnel Configuration mode, enter the interface tunnel command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface tunnel 1
(config-tunnel 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
bandwidth <value>
crypto map <mapname>
dial-backup commands
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password>
on page 990
ip commands
begin on page 992
keepalive <period> <retries>
lldp receive
on page 1017
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
mtu <size>
on page 1020
tunnel checksum
on page 1021
tunnel destination <ip address>
tunnel key <value>
tunnel mode gre
on page 1024
tunnel sequence-datagrams
tunnel source [<ip address> | <interface>]
61200990L1-35E
C
OMMAND
on page 31
on page 968
on page 971
on page 972
begin on page 974
on page 1016
on page 1018
on page 1022
on page 1023
on page 1025
Copyright © 2005 ADTRAN
Tunnel Configuration Command Set
S
ET
on page 1026
967
- Quick Links:
- Basic Mode Command Set
- Common Commands
Hide quick links:
Advertisement
Table of Contents
