Tdm-Group (T1 Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
tdm-group <group number> timeslots <1-24> speed [56 | 64]
Use the tdm-group command to create a group of contiguous DS0s on this interface to be used during the
cross-connect process. Refer to crypto map <mapname>
Changing tdm-group settings could result in service interruption.
Syntax Description
<group number>
timeslots <1-24>
speed [56 | 64]
Default Values
By default, there are no configured TDM groups.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example creates a TDM group (labeled 5) of 10 DS0s at 64 kbps each:
(config)#interface t1 1/1
(config-t1 1/1)#tdm-group 5 timeslots 1-10 speed 64
61200990L1-35E
Identifies the created TDM group (valid range: 1 to 255).
Specifies the DS0s to be used in the TDM group. This can be entered as a single
number representing one of the 24 T1 channel timeslots or as a contiguous group
of DS0s. (For example, 1-10 specifies the first 10 channels of the T1.)
Optional. Specifies the individual DS0 rate on the T1 interface to be 64 kbps. Only the
T1 + DSX-1 Network Interface Module supports the 56 kbps DS0 rate. The default
speed is 64 kbps.
Command was introduced.
Copyright © 2005 ADTRAN
T1 Interface Configuration Command Set
on page 896 for related information.
618