Demand-Hold-Queue Timeout Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
demand-hold-queue <packets> timeout <seconds>
Use the demand-hold-queue timeout command to set the number and length of time interesting packets
will be held while a connection is being made. Use the no form of this command to restore the default
values.
Syntax Description
<packets>
<seconds>
Default Values
By default, the hold queue is disabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 11.1
Usage Examples
The following example configures demand interface 1 to hold 50 packets in the queue for up to
120 seconds:
(config)#interface demand 1
(config-demand 1)#demand-hold-queue 50 timeout 120
61200990L1-35E
Specifies the number of packets that may be stored in the hold queue. Range is 0
to 100.
Specifies the number of seconds a packet may remain in the hold queue. Range
is 0 to 255 seconds.
Command was introduced.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
647