Aaa Processes Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
aaa processes <threads>
Use the aaa processes command to set the number of threads available to the AAA subsystem. Use the no
form of this command to return to the default setting. For more detailed information on AAA functionality,
refer to the Technology Review section of the command aaa on
Syntax Description
<threads>
Default Values
By default, this is set to 1 process.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 5.1
Functional Notes
Increasing this number may speed up simultaneous authentication at the cost of system resources
(e.g., memory).
Usage Examples
The following example specifies five available threads for the AAA subsystem:
(config)#aaa processes 5
61200990L1-35E
Specifies the number of threads available to the AAA subsystem. Range: 1 to 64.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
on page 296.
298