Idle-Timeout Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
idle-timeout <seconds>
Use the idle-timeout command to set the amount of time the interface link/bundle will remain up in the
absence of interesting traffic. Interesting traffic and direction logic are set using the match-interesting
commands. Refer to match-interesting [list <acl name> | reverse list <acl name>] [in | out]
for more information. Use the no form of this command to restore the default values.
Syntax Description
<seconds>
Default Values
By default, idle-timeout is set to 120 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 11.1
Usage Examples
The following example configures demand interface 1 to time out after 360 seconds:
(config)#interface demand 1
(config-demand 1)#idle-timeout 360
61200990L1-35E
Specifies the number of seconds the interface will remain up in the absence of
interesting traffic. Range is 1 to 2,147,483.
Command was introduced.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
on page 677
653