Ip Dhcp-Server Pool Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip dhcp-server pool <name>
Use the ip dhcp-server pool command to create a DHCP address pool and enter the DHCP pool. Use the
no form of this command to remove a configured DHCP address pool. Refer to the section DHCP Pool
Command Set on page 1145
Syntax Description
<name>
Default Values
By default, there are no configured DHCP address pools.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 2.1
Functional Notes
Use the ip dhcp-server pool to create multiple DHCP server address pools for various segments of the
network. Multiple address pools can be created to service different segments of the network with tailored
configurations.
Usage Examples
The following example creates a DHCP server address pool (labeled SALES) and enters the DHCP server
pool mode:
(config)#ip dhcp-server pool SALES
(config-dhcp)#
61200990L1-35E
for more information.
Identifies the configured DHCP server address pool using an alphanumeric string
(up to 32 characters in length).
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
361