Fair-Queue - To Use The Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
fair-queue <threshold>
Use the fair-queue command to enable weighted fair queuing (WFQ) on an interface. Use the no form of
this command to disable WFQ and enable FIFO (first-in-first-out) queueing for an interface. WFQ is
enabled by default for WAN interfaces.
Syntax Description
<threshold>
Default Values
By default, fair-queue is enabled with a threshold of 64 packets.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1
Usage Examples
The following example enables WFQ on the interface with a threshold set at 100 packets:
(config)#interface hdlc 1
(config-hdlc 1)#fair-queue 100
61200990L1-35E
Optional. Value that specifies the maximum number of packets that can be present
in each conversation sub-queue. Packets received for a conversation after this
limit is reached are discarded. Range: 16 to 512.
Command was introduced.
Copyright © 2005 ADTRAN
HDLC Command Set
810