Remote-Loopback (T3 Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide T3 Interface Configuration Command Set
remote-loopback
Use the remote-loopback command to configure the T3 interface to be looped from the far end (remote
device, telco, etc.). Use the no form of this command to disable this feature.
Syntax Description
No subcommands.
Default Value
By default, all interfaces respond to remote loopbacks.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1 Command was introduced.
Usage Examples
This example enables remote loopbacks on the T3 interface:
(config)#interface t3 1/1
(config-t3 1/1)#remote-loopback
61200990L1-35E Copyright © 2005 ADTRAN 627