Command Reference Guide
join-prune-msg-interval <seconds>
Use the join-prune-msg-interval command to set a timing rate for PIM sparse join/prune messages.
Syntax Description
<seconds>
Default Values
By default, the message interval is set to 60 seconds.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and the Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example sets the interval for 50 seconds:
(config)#router pim-sparse
(config-pim-sparse)#join-prune-msg-interval 50
61200990L1-35E
Specifies the PIM sparse join/prune message interval.
Valid range: 10 to 65534 seconds.
Command was introduced.
Copyright © 2005 ADTRAN
Router (PIM Sparse) Configuration Command Set
1130