Area Range Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
area <area id> range <ip address> <network mask> [advertise |
not-advertise]
Use the area range command to configure area route summarizations and to determine whether an address
range is advertised to the networks.
Syntax Description
<area id>
<ip address>
<network mask>
advertise
not-advertise
Default Values
By default, OSPF is not enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Usage Examples
The following example defines an address range for a specific area that allows the unit to advertise this
range to other networks:
(config)#router ospf
(config-ospf)#area 11.0.0.0 range 11.0.0.0 255.0.0.0 advertise
61200990L1-35E
Specifies an identifier for this area. Specifies as an integer (range: 0 to
4,294,967,295) or an IP address <A.B.C.D>.
Specifies the IP address of the advertised summary route.
Specifies the mask of the advertised summary route.
Specifies the specified address range will be advertised to other networks.
Specifies the specified address range will not be advertised to other networks.
Command was introduced.
Copyright © 2005 ADTRAN
Router (OSPF) Configuration Command Set
1116