Ip Route-Cache Command (Loopback Interface Configuration) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip route-cache
Use the ip route-cache command to enable fast-cache switching on the interface. Use the no form of this
command to disable fast-cache switching and return to process switching mode.
Using Network Address Translation (NAT) or the AOS firewall capabilities on an interface
requires process switching mode (using the no ip route-cache command).
Syntax Description
No subcommands.
Default Values
By default, fast-cache switching is enabled on all Ethernet and virtual Frame Relay sub-interfaces. IP
route-cache is enabled for all virtual PPP interfaces.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 2.1
Functional Notes
Fast switching allows an IP interface to provide optimum performance when processing IP traffic.
Usage Examples
The following example enables fast switching on the loopback interface:
(config)#interface loopback 1
(config-loop 1)#ip route-cache
61200990L1-35E
Command was introduced.
Copyright © 2005 ADTRAN
Loopback Interface Configuration Command Set
878