Bridge-Group - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
bridge-group <group#>
Use the bridge-group command to assign an interface to the specified bridge group. Use the no form of
this command to remove the interface from the bridge group.
Syntax Description
<group#>
Default Values
By default, there are no configured bridge groups.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1
Functional Notes
A bridged network can provide excellent traffic management to reduce collisions and limit the amount of
bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can
be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay sub-interface, etc.).
Usage Examples
The following example assigns the HDLC interface labeled 1 to bridge-group 1:
(config)#interface hdlc 1
(config-hdlc 1)#bridge-group 1
61200990L1-35E
Specifies bridge group number (1 to 255) specified using the bridge-group
command
Command was introduced.
Copyright © 2005 ADTRAN
HDLC Command Set
789