Show Lldp Interface Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show lldp interface <interface>
Use the show lldp interface command to display local loop demarkation point (LLDP) configuration and
statistics for interfaces on this device.
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1
Usage Examples
The following example shows LLDP configuration and statistics for the Ethernet 0/1 interface:
>enable
#show lldp interface ethernet 0/1
eth 0/1 (TX/RX)
0 packets input
0 input errors
0 TLV errors, 0 TLVs Discarded
0 packets discarded
8799 packets output
0 neighbor ageouts
#
61200990L1-35E
Displays the information for the specified interface. Type show lldp interface ?
for a complete list of applicable interfaces.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
233