Ip Pim-Sparse Dr-Priority Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip pim-sparse dr-priority <priority number>
Use the ip pim-sparse dr-priority command to specify the priority for the designated router (DR). This
command modifies the routers priority in the DR election process. Use the no form of this command to
return to the default value.
Syntax Description
<priority number>
Default Values
By default, the DR priority is set to 1.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example sets the DR priority to 5:
(config)#interface eth 0/1
(config-eth 0/1)#ip pim-sparse dr-priority 5
61200990L1-35E
Specifies the priority number for the DR router. Valid range is 1 to 4,294,967,295.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
562