Speed Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
speed <rate>
Use the speed command to specify the data rate for the
VT100 terminal emulator or emulator software. Use the no form of this command to restore the default
value.
Syntax Description
<rate>
Default Values
By default, the speed is set to 9600 bps.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example configures the CONSOLE port for 19200 bps:
(config)#line console 0
(config-con 0)#speed 19200
61200990L1-35E
Specifies rate of data transfer on the interface (2400; 4800; 9600; 19,200; 38,400;
57,600; or 115,200 bps).
Command was introduced.
Copyright © 2005 ADTRAN
Line (Console) Interface Config Command Set
port. This setting must match your
CONSOLE
481