Router (Rip) Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
R (RIP) C
OUTER
To activate the Router (RIP) Configuration mode, enter the router rip command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router rip
(config-rip)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
auto-summary on page 1135
timeout-timer <seconds>
network <address> <subnet mask>
passive-interface <interface>
redistribute connected [metric <value>]
redistribute ospf [metric <value>]
redistribute static [metric <value>]
timeout-timer <seconds>
update-timer <seconds>
version [1 | 2] on page 1144
61200990L1-35E
ONFIGURATION
on page 1142
on page 1137
on page 1138
on page 1139
on page 1140
on page 1141
on page 1142
on page 1143
Copyright © 2005 ADTRAN

Router (RIP) Configuration Command Set

C S
OMMAND ET
1134