Set Local-Preference Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
set local-preference <value>
Use the set local-preference command to restrict traffic to a local autonomous system. Use the no form of
this command to cancel the local preference.
Syntax Description
<value>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series and
Total Access 900 Series units.
Command History
Release 10.1
Usage Examples
The following example sets the local preference fro MyMap to a value of 100:
(config)#route-map MyMap permit 100
(config-route-map)#set local-preference 100
61200990L1-35E
Sets the local preference value. (Valid range: 0 to
4,294,967,295.)
Command was introduced.
Copyright © 2005 ADTRAN
Route Map Command Set
1182