Ip Rip Receive Version - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide

ip rip receive version [1 | 2]

Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1
Functional Notes
Use the ip rip receive version command to specify a RIP version that will override the version (in the
Router RIP) configuration.
The AOS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures a Frame Relay sub-interface to accept only RIP version 2 packets:
(config)#interface frame-relay 1.16
(config-fr 1.16)#ip rip receive version 2
61200990L1-35E
Accepts only received RIP version 1 packets on the interface.
Accepts only received RIP version 2 packets on the interface.
Command was introduced.
Copyright © 2005 ADTRAN
Frame Relay Sub-Interface Config Command Set
768