Loopback Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
loopback [dce | dte | line | remote | none]
Use the loopback command to initiate or remove a loopback.
Syntax Description
dce
dte
line
remote
none
Default Values
By default, no loopbacks are active.
Applicable Platforms
This command applies to the NetVanta 5000 Series units.
Command History
Release 7.1
Usage Examples
The following example initiates a local line loopback on the HSSI interface:
(config)#interface hssi 1/1
(config-hssi 1/1)#loopback line
61200990L1-35E
Initiates a loopback on the DCE.
Initiates a loopback on the DTE.
Initiates a local line loopback.
Initiates a remote line loopback.
Removes an active loopback.
Command was introduced.
Copyright © 2005 ADTRAN
HSSI Interface Configuration Command Set
601