Bandwidth (Quality Of Service (Qos) Map Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
bandwidth [percent | remaining | <value> ]
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
percent
remaining
<value>
Default Values
By default, there is no bandwidth configured for a QOS map entry.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 9.1
Release 10.0
Functional Notes
When configuring entries within a QOS map set in Rev. 10, there are a few rules to be aware of:
1. The units of the bandwidth (kbps, percent, or remaining percent) must be consistent for all class-based
entries (use the bandwidth command) in a QOS map set.
2. The total bandwidth between all priority entries and class-based entries in a QOS map set should not
be configured beyond 75 percent of the bandwidth on the interface that the qos-policy is applied to, or
the map will not be used.
3. Up to four class-based entries can be configured on a particular QOS map set that is applied to an
interface. Up to sixteen class-based entries can be configured in the box (four entries on four QOS
maps).
Usage Examples
The following example sets bandwidth of the QoS map to 10 Mbps:
(config)#qos map 1
(config-qos-map 1)#bandwidth 10000
61200990L1-35E
Specifies percent of total interface bandwidth.
Specifies percent of total interface bandwidth minus any priority entry bandwidth
values on this QOS map.
Specifies the bandwidth value in kbps. Valid range is from 8 to 2000000
Command was introduced.
New subcommands percent and remaining were added.
Copyright © 2005 ADTRAN
Quality of Service (QoS) Map Commands
1164