Dial-Backup Backup-Delay - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
dial-backup backup-delay <seconds>
Use the dial-backup backup-delay command to configure the amount of time the router will wait after the
failure condition is recognized before attempting to backup the link. Use the no form of this command to
return to the default value. For more detailed information on PPP dial-backup functionality, refer to the
Functional Notes and Technology Review sections of the command.
Syntax Description
<seconds>
Default Values
By default, the dial-backup backup-delay period is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1
Release 5.1
Usage Examples
The following example configures the AOS to wait 60 seconds (on an endpoint with an active alarm
condition) before attempting dial-backup operation:
(config)#interface ppp 1
(config-ppp 1)#dial-backup backup-delay 60
61200990L1-35E
Specifies the delay period (in seconds) a failure must be active before the AOS
will enter backup operation on the interface. Range: 10 to 86,400 seconds.
Command was introduced.
Command was expanded to include the PPP interface.
Copyright © 2005 ADTRAN
HDLC Command Set
794