Set Peer Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
set peer <address>
Use the set peer command to set the IP address of the peer device. This must be set for multiple remote
peers.
Syntax Description
<address>
Default Values
There are no default settings for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Functional Notes
If no peer IP addresses are configured, the entry will only be used to respond to IPSec requests; it cannot
initiate the requests (since it doesn't know which IP address to send the packet to). If a single peer IP
address is configured, the crypto map entry can be used to both initiate and respond to SAs.
The peer IP address is the public IP address of the device which will terminate the IPSec tunnel. If the peer
IP address is not static, the ADTRAN product cannot initiate the VPN tunnel. By setting no peer IP
address, the ADTRAN product can respond to an IPSec tunnel request.
Usage Examples
The following example sets the peer IP address of 10.100.23.64:
(config-crypto-map)#set peer 10.100.23.64
61200990L1-35E
Specifies the IP address of the peer device. If this is not configured, it implies
responder only to any peer.
Command was introduced.
Copyright © 2005 ADTRAN
Crypto Map IKE Command Set
1048